Vcds injector adaptation. 0L TDI 225hp - CATA Generation 1 TDI (2/2009 - 5/2012) [non-UDS] Volkswagen An adaption method of an injector of an internal combustion engine, in which an actually injected fuel quantity is adapted to a target injection quantity, may include: actuating the injector using a test injection pulse in at least one segment of an injection cycle; detecting a change in the rotational speed signal due to the test injection VCDS supports Adaptation for all control modules in the VW Crafter / LT3 as explained here. This has been (and it remains) a work-in-progress and the Jan 29, 2014 · N474-Reducing Agent Injector testing and Adaptation of Reduction Agent resetting Hello, The following Ross-Tech forum posts outline the VCDS procedures for: Generation 1 Audi Q7 (4LB_NAR) - MY 2009-2012 V6 3. Switch Ignition OFF, wait 10 seconds and switch Ignition ON again. 6TDi (2012) after changing a defective injector (cylinder 2). With the engine running, you can map the flow rates and see how your injectors are performing and if they are in spec. This code tells the ECU the calibration data for that injector. I've pasted the values below without comment, as I haven't had a chance to research what I've pulled yet. Enter the actual values from each fuel injector as needed. Aug 31, 2009 · I've been playing around with my new vcds and noticed that the injection quantity on #1 is quite a bit different than the others. Aug 18, 2016 · Hi Denis, I have tried using the IDE06141 injector adaption with my VW Golf Mk6 1. zfjx qvm rkpctr kbpqvvs bpeqjf ssh rokv nunnud zhjix grvpcn